Check Status LEDs No Status LEDs Check Software to see for low batteryIf state looks normal - Follow directions for new MiTag Blue Light flashing Device is out of range of GatewayCheck for physical obstructionsMove MiTag Sensor closer to Gateway or move Gateway closer to sensorWhen back in range, MiTag will automatically start...
Press red panic button for 3-5 seconds to wake: If no Status LEDs flash Possible for dead battery Reset button (5 secs to boot) Reseat battery · Recommendations, take off battery cover and tap, do not use tools (may damage hardware)
I am going to install the MiSensors to a cellular router, how much data does 1 MiTag sensor produce?Dave Scowby
Each MiTag produces approximately 100MB of cellular data per month reporting sensors values every 5 seconds.
The MiTag Sensor collects and sends data to our servers every 60 seconds.
Up to 100 Sensors.
-40 to 85°C, Accuracy +/- 0.5 degrees
Yes. It is IP67 rated and can be dropped into a body of water up to a meter deep for up to 30 minutes.
Up to 300 Feet (100 Meters). The signal distance is based on the installation environment. The distance is reduced in environments exposed to interference, such as building structures, materials and radio waves.
Appropriately 2 years. They are replaceable with a Coin Cell CR2477 Battery.
Coin Cell CR2477 Batteries.