MiTag Multi-Sensor – Release Notes

MiTag Multi-Sensor – Release Notes

1.1.0
December 21, 2020
Added
LED Sequence - Fix issue that caused MiTag status LED sequence to wrongly indicate that a MiTag is detected, when the system goes from ‘MiTags detected' to 'No MiTags detected’
Fixed
LED Sequence - When displaying the blinking sequence to indicate individual MiTag and Network status, separate the subsystem blink patterns with a 1.5 second of 'LEDs Off' time to ease the understanding of the blink pattern
Updated
LED Sequence - If either MiTags are not detected or Network is not connected, switch to the existing blink pattern which uses Dark Orange and Yellow are subsystem LED colors and Green as status indicator
Updated
LED Sequence - When All Systems are good, (MiTags are detected and Network is connected), LED becomes solid Green, with two rapid blinks every 5 seconds
Updated
MQTT - INSTALL - Add support to verify installation through MQTT message reception
1.0.1
November 12, 2020
Updated
Accommodate reduction of size of lux field in BLE advertisement from 4 bytes to 2 bytes in MiTag firmware 1.1
1.0.0
November 10, 2020
Updated
Include Light Sensor value in Sensor Data Messages and Alert messages
Improved
Optimize cloud data usage. Connect only when there is data
Added
Detect and post Motion Alerts
Added
Add mechanism to send version message periodically as specified by the gatewayVersMsgInterval configuration parameter (default every 12 hours)
0.7.5
September 18, 2020
Added
Define new config parameter (factory default 60 seconds) to define interval between two successive MQTT Sensor Data messages
Updated
Clean up all debug to be enhance readability of MiTags, their MAC addresses message send timestamp etc
0.7.4
September 18, 2020
Updated
LED Sequence - Change Comm Status LED to be Dark Orange instead of Red to look less alarming
0.7.3
September 16, 2020
Improved
LED Sequence - Improve detecting network failure and reflecting in LED blink pattern
Added
LED Sequence - Implement a startup sequence: Red blinks twice, Green Blinks twice and then Yellow blinks twice
Added
Added support for Watchdog protection
0.7.2
February 12, 2021

Implementing new LED Behavior

Added
LED Sequence - MiTag Detected and Comms Connected (All Devices Good): Red solid ON for 2 seconds and OFF - Green solid ON for 1 second and OFF - Yellow solid ON for 2 seconds and OFF - Green Solid ON for 1 second and OFF
Added
LED Sequence - MiTag Detected: Yellow Solid ON for 2 seconds and OFF, Green solid ON for 1 second and OFF
Added
LED Sequence - MiTag not Detected: Yellow Solid ON for 2 seconds, then Green Blinks 5 times and OFF
Added
LED Sequence - Comms Connected: Red Solid ON for 2 seconds and OFF, Green solid ON for 1 second and OFF
Added
LED Sequence - Comms not Connected: Red Solid ON for 2 seconds, then Green Blinks 5 times and OFF
Added
LED Sequence - Use Yellow LED for Bluetooth | Use Red LED for Comms | Use Green LED for Status Indicator
0.7.0
August 14, 2020
Added
Remote Update support for MiBridge Firmware
0.6.0
August 06, 2020
Added
Support for serial firmware update