MiGateway Ethernet – Release Notes

MiGateway Ethernet – Release Notes

1.6
February 18, 2021
Improved
BATT - Improve battery voltage accuracy by sampling voltage 200 milliseconds after BLE Transmit completes
Added
SERIAL/STARTUP - Detect if external serial cable/Jig is connected. If none detected, go into the Production Mode directly
1.5
December 23, 2020
Improved
Remove existing requirement for battery voltage to be above 2.3V for startup
Updated
When voltage is below 2.4V, deactivate light detection to conserve battery life
Updated
Reduce BLE advertisement cut off voltage from 2.5V to 2.1V based on results from temperature chamber tests
1.4
December 04, 2020
Improved
Reduce power consumption so the battery lasts for at least 2 years
1.3
November 20, 2020
Added
BATT - Add scheme to disable operation on Low Battery (< 2.5V)
Added
IMPACT - Reconfigure the accelerometer to reduce the sensitivity and generate alerts on an impact instead of just slow movement
Fixed
Light Sensor - Calibrate with a lux meter and fix inaccuracies with the lux values reported
Fixed
Fix for unexpected reset during sleep, due to possible race condition wrt driving the UART RX pin
1.2
November 13, 2020
Added
Report version in the BLE advertisement by repurposing the 2 MSBytes of lux
1.0.0
October 23, 2020

Official Release

Added
Multi-Function button press causes Red LED to blink twice brightly (and then goes to feeble blink) to provide feedback on button press
Updated
Heartbeat LED is Blue and Door status change is Blinking Green LED
Updated
Enables all sensors including light
0.6.9
October 12, 2020
Updated
Change activity LED to Green and Door status LED to Blue.
Added
Detect any initialization issues with sensors, timers, GPIO handlers etc. and reset if any errors are detected at startup. Blink red LED three times before restarting if errors detected
Improved
Improve BLE broadcast range by 1.6 times (3 to 4 uA additional drain)
0.6.8
September 23, 2020
Updated
When Multi-Function Button Activated - Red LED is active, Blue LED to be inactive
Updated
Green LED blinks rapidly for Door Status Change - Updated from Blue
Improved
Updated Light Sensor to reduce power consumption
0.6.1
September 15, 2020
Updated
Blue LED blinks once quickly for Door Status Change
Updated
Green LED blinks for activity - Changed from Blue
0.6.0
September 07, 2020
Added
Added Support for DFU OTA over BLE
Added
Added Support for Light Sensor
0.5.0
September 03, 2020
Updated
Red LED Blinks rapidly when Multi-function is active (No Blue LED when Panic is active)
Updated
Green LED Blinks rapidly on Door Status change
Added
Blue, Red and Green LED Turn On/Off in Sequence to indicate startup
Added
Movement count is broadcast in advertisement
0.1.0
August 06, 2020

Initial Release

Added
Blue LED Solid ON for 10 seconds - Multi-Function Button Activated
Added
Green LED Solid ON - indicates Door Closed
Added
Blue LED blinks rapidly every 2 seconds - indicates a live Tag